Flash-To-Pass

You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.

NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.

    See also:

    Windshield Washers
    To use the washer, pull the windshield wiper/washer control lever toward you and hold it for as long as washer spray is desired (for a maximum of 10 seconds). If you activate the washer while the ...

    Average Fuel Economy
    Shows the average fuel economy since the last reset. Average Fuel Economy can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset, the history informa ...

    Soft Top — Four-Door Models
    Please visit the owner’s section of Jeep.com for instructional videos. CAUTION! The soft top is not designed to carry any additional loads such as roof racks, spare tires, building, hunting, or ...