Using HomeLink
To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may also be used at any time.
See also:
To Set The Variance
Start the engine and leave the transmission gear selector lever in the PARK position.
Press and hold the RESET button on the steering wheel (for approximately ten seconds)
until the current varian ...
Operating Tips
NOTE: Refer to the chart at the end of this section for
suggested control settings for various weather conditions. ...
Fluid Level Check
The fluid level should be to the bottom edge of the fill hole (A) when the vehicle
is in a level position.
...