Electronic Vehicle Information Center (EVIC) Displays

When the appropriate conditions exist, the EVIC displays the following messages:
• Low Tire Pressure
• Spare Low Pressure
• Premium TPMS Graphic Display
• Key in Ignition
• Turn Signal On (with a continuous warning chime)
• Left Front Turn Signal Lamp Out (with a single chime)
• Left Rear Turn Signal Lamp Out (with a single chime)
• Right Front Turn Signal Lamp Out (with a single chime)
• Right Rear Turn Signal Lamp Out (with a single chime)
• Key Fob Battery Low (with a single chime)
• Memory #1/#2 Profile Set
• Memory #1/#2 Profile Recall
• Memory System Disabled – Vehicle Not in Park (with a single chime) — automatic transmission
• Memory System Disabled – Vehicle in Motion (with a single chime) — manual transmission
• Memory System Disabled – Seat Belt Buckled (with a single chime)
• Personal Settings Not Avail – Vehicle Not in Park — automatic transmission
• Personal Settings Not Avail – Vehicle in Motion — manual transmission
• Door Ajar (with vehicle graphic showing which door is open. A single chime sounds if the vehicle is in motion)
• Doors Ajar (with vehicle graphic showing which doors are open. A single chime sounds if the vehicle is in motion)
• Gate (with vehicle graphic showing the Liftgate open and A single chime)
• Low Tire (with a graphic of the car showing which tire(s) is/are low — with a single chime)
• Service TPM System (with a single chime). Refer to “Tire Pressure Monitoring System” in “Starting And Operating”.
• Check Gascap (refer to “Adding Fuel” in “Starting And Operating” for more details)
• Service Park Assist System (with a single chime)
• Oil Change Required (with a single chime)
• ECO (Fuel Saver Indicator) — if equipped

    See also:

    Compass Variance
    Refer to “Compass Display” for more information. ...

    Intermittent Wiper System
    Use the intermittent wiper system when weather conditions make a single wiping cycle with a variable pause between cycles desirable. Rotate the end of the windshield wiper/washer control lever t ...

    Operation
    Voice commands can be used to operate the Uconnect™ Phone and to navigate through the Uconnect™ Phone menu structure. Voice commands are required after most Uconnect™ Phone prompts. You wi ...