Rain Sensing Intermittent Wipers — If Equipped
When ON is selected, the system will automatically activate the windshield wipers if it senses moisture on the windshield. To make your selection, press and release the SELECT button until “ON” or “OFF” appears. When OFF is selected, the system reverts to the standard intermittent wiper operation.
See also:
Lap/Shoulder Belt Operating Instructions
1. Enter the vehicle and close the door. Sit back and
adjust the seat.
2. The seat belt latch plate is located on the B-Pillar along
the outboard side and rear of the seat cushion. The rear
sea ...
Door Frame Installation — Four-Door Models
1. Install the rear door frame first.
2. Set the door frame pin into the hole on top of the body side, just behind
the rear door opening.
3. Position the top of the door frame against the metal ...
Installing The Soft Top
NOTE: The following procedures are for first time set up only. For future
soft top procedures, refer to “Soft Top” in this section.
1. Locate and remove the following items prior to hard top re ...