Setup

To switch to system setup, you may say on of the following:
• “Change to setup”
• “Switch to system setup”
• “Change to setup”
• “Main menu setup” or
• “Switch to setup”

In this mode, you may say the following commands:
• “Language English”
• “Language French”
• “Language Spanish”
• “Tutorial”
• “Voice Training”

NOTE: Keep in mind that you have to press the Voice Command for the beep before button first and wait for the beep before speaking the “Barge In” commands.

    See also:

    Ignition Off Operation
    The power sunroof switches can be programmed to remain active for up to approximately ten minutes after the ignition switch has been turned OFF. Refer to “Electronic Vehicle Information Center ...

    Adaptive Cruise Control (ACC) Menu
    The EVIC displays the current ACC system settings. The EVIC is located in the upper part of the instrument cluster between the speedometer and the tachometer. The information it displays depends ...

    Keyless Enter-N-Go Display — If Equipped
    When the ENGINE START/STOP button is pressed to change ignition switch positions, the Keyless Enter-N-Go icon momentarily appears in the lower right corner of the EVIC display showing the new ig ...