Quadra-Trac I Operating Instructions/Precautions – If Equipped
The Quadra-Trac I is a single-speed (HI range only) transfer case, which provides convenient full-time fourwheel drive. No driver interaction is required. The Brake Traction Control (BTC) System, which combines standard ABS and Traction Control, provides resistance to any wheel that is slipping to allow additional torque transfer to wheels with traction.
NOTE: The Quadra-Trac I system is not appropriate for conditions where 4WD LOW range is recommended.
Refer to “Off-Road Driving Tips” in “Starting and Operating” for further information.
See also:
Front Panel(s) Installation
NOTE: Set the panels on the windshield frame so that there is no overhang.
Also, make sure that the panels are sitting flush with the body.
1. Install the right panel first, then the left panel.
2 ...
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink ...
Starting Procedures
Before starting your vehicle, adjust your seat, adjust the
inside and outside mirrors, fasten your seat belt, and if
present, instruct all other occupants to buckle their seat
belts.
WARNING!
...