Closing The Sunrider
1. Remove the straps from the side bows.
2. Unclip and move the sun visors to the side.
3. Grasp the front header and pull it to the front of the vehicle.
4. Hook the header latches to the loops on the windshield frame, close latches, and return the sun visors to their original positions.
5. Slide the plastic sleeve rearward over the Sunrider link.
See also:
Front Axle Fluid Level Check
The front axle oil level needs to be between 1/8 in (3 mm)
below the bottom of the fill hole and the bottom of the fill
hole.
The front axle fill and drain plugs should be tightened to
22 to 29 ...
Exterior
Over the past few years, Jeep has consistently designed vehicles in the vein
of its beloved Cherokee of the 1980s — the large Commander and small Patriot
both share that look. The Liberty once h ...
Automatic Locking Retractor Mode (ALR) — If Equipped
In this mode, the shoulder belt is automatically prelocked.
The belt will still retract to remove any slack in the shoulder belt. The Automatic
Locking Mode is available on all passenger-seating po ...


