To Disable A RKE Transmitter Linked To Memory
1. Turn the ignition switch to the LOCK position, and remove the key.
2. Press and release MEMORY button number 1. The system will recall any memory settings stored in position 1. Wait for the system to complete the memory recall before continuing to Step 3.
3. Press and release the memory S (SET) button located on the driver’s door.
4. Within five seconds, press and release MEMORY button 1 on the driver’s door.
5. Within five seconds, press and release the UNLOCK button on the RKE transmitter.
To disable another RKE transmitter linked to either memory position, repeat steps 1 through 5 for each RKE transmitter.
NOTE: Once programmed, all RKE transmitters linked to memory can be easily enabled or disabled at one time.
Refer to “Electronic Vehicle Information Center (EVIC)/ Customer-Programmable Features” in “Understanding Your Instrument Panel” for further information.
See also:
Power Steering Fluid Check
Checking the power steering fluid level at a defined
service interval is not required. The fluid should only be
checked if a leak is suspected, abnormal noises are
apparent, and/or the system is ...
Safety
Jeep didn't skimp on the Compass' standard safety features. In addition to
the more common ABS and traction control are an electronic stability system and
side curtain-type airbags. Seat-mounted s ...
Lowering The Windshield And Removing Side Bars
1. Lower the fabric top or remove the hard top following the instructions in
this manual.
NOTE: To assist in properly reinstalling side bars, mark the original locations
prior to removing.
2. Re ...