Listening To Audio With The Screen Closed
To listen to only audio portion of the channel with the screen closed:
• Set the audio to the desired source and channel.
• Close the video screen.
• To change the current audio mode, press the remote control’s MODE button. This will automatically select the next available audio mode without using the Mode Select menu.
• When the screen is reopened, the video screen will automatically turn back on and show the appropriate display menu or media.
If the screen is closed and there is no audio heard, verify that the headphones are turned on (the ON indicator is illuminated) and the headphone selector switch is on the desired channel. If the headphones are turned on, press the remote control’s power button to turn audio on. If audio is still not heard, check that fully charged batteries are installed in the headphones.
See also:
Customer-Programmable Features (System Setup)
Personal Settings allows you to set and recall features
when the transmission is in PARK. If the transmission is
out of PARK or the vehicle begins moving, a warning
message SETUP NOT AVAILABLE, ...
Cruise Control
Press and release the UP or DOWN button until ACC (if
equipped with Adaptive Cruise Control) or Cruise is
highlighted in the EVIC. Status of the ACC or Cruise is
displayed in the menu line also. ...
Cleaning The Parksense System
Clean the ParkSense sensors with water, car wash soap
and a soft cloth. Do not use rough or hard cloths. Do not
scratch or poke the sensors. Otherwise, you could damage
the sensors. ...


