Preparations For Jump-Start
The battery in your vehicle is located under the passenger’s front seat. There are remote locations located under the hood to assist in jump-starting.

Remote Battery Posts
1 — Remote Positive (+) Post (covered with protective cap)
2 — Remote Negative (-) Post
WARNING!
• Take care to avoid the radiator cooling fan whenever
the hood is raised. It can start anytime the
ignition switch is on. You can be injured by
moving fan blades.
• Remove any metal jewelry such as watch bands or bracelets that might make an inadvertent electrical contact. You could be seriously injured.
• Batteries contain sulfuric acid that can burn your skin or eyes and generate hydrogen gas which is flammable and explosive. Keep open flames or sparks away from the battery.
1. Set the parking brake, shift the automatic transmission into PARK and turn the ignition to LOCK.
2. Turn off the heater, radio, and all unnecessary electrical accessories.
3. Remove the protective cover over the remote positive (+) battery post. Pull upward on the cover to remove it.
4. If using another vehicle to jump-start the battery, park the vehicle within the jumper cables reach, set the parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
See also:
Automatic Locking Retractor Mode (ALR) — If Equipped
In this mode, the shoulder belt is automatically prelocked.
The belt will still retract to remove any slack in the shoulder belt. The Automatic
Locking Mode is available on all passenger-seating po ...
Sunrider (Four-Door Models) — If Equipped
CAUTION!
Operating the top, opening a door or lowering a window while the top is wet may
allow water to drip into the vehicle’s interior.
NOTE: If you are going to be driving faster than 40 mph ...
Tread Wear Indicators
Tread wear indicators are in the original equipment tires
to help you in determining when your tires should be
replaced.
1 — Worn Tire
2 — New Tire
These indicators are molded into the b ...


