Go-Anywhere 4x4 Systems
The 2011 Jeep Grand Cherokee offers three 4x4 systems (Quadra-Trac I®, Quadra-Trac II® and Quadra-Drive® II).
Quadra Trac I delivers full-time four-wheel drive without any switches or levers to pull. The system provides smooth operation over a variety of road conditions. This light-weight single-speed case is both proven and highly efficient for enhanced fuel economy.
Quadra Trac II's two-speed transfer case uses input from a variety of sensors in order to determine tire slip at the earliest possible moment and take corrective action. The system uses Throttle Anticipate to sense quick movement in the throttle from a stop and maximizes traction before slippage occurs. When tire slippage is detected, as much as 100 percent of available torque is instantly routed to the axle with the most traction.
Quadra Drive II, with a rear Electronic Limited-Slip Differential (ELSD), delivers industry-leading tractive capability. The system instantly detects tire slip and smoothly distributes engine torque to tires with traction. In some cases, the vehicle will anticipate low traction and adjust in order to proactively limit or eliminate slip.
Selec-Terrain is standard with Quadra Trac II and Quadra Drive II.
See also:
Replacement Parts
Use of genuine MOPAR parts for normal/scheduled
maintenance and repairs is highly recommended to ensure
the designed performance. Damage or failures
caused by the use of non-MOPAR parts for main ...
ESN/SID Access
With the ignition switch in the ON/RUN or ACC position and the radio on, press
the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is
selected. Press the TUNE/SCROLL con ...
Service ACC Warning
If the system turns off, and the EVIC displays “ACC/
FCW Unavailable Service Radar Sensor”, it indicates
there is an internal system fault. Although the vehicle is
still drivable under norma ...


