To Open And Close The Hood

To open the hood, two latches must be released.

1. Pull the release lever located below the instrument panel and in front of the driver’s door.

Hood Release Hood Release

2. Reach under the hood, move safety latch to the left and lift the hood.

Safety Latch Location
Safety Latch Location

CAUTION!
To prevent possible damage, do not slam the hood to close it. Use a firm downward push at the center of the hood to ensure that both latches engage.

WARNING!
Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched, it could open when the vehicle is in motion and block your vision.

Failure to follow this warning could result in serious injury or death.

    See also:

    American Petroleum Institute (API) Engine Oil Identification Symbol
    This symbol means that the oil has been certified by the American Petroleum Institute (API). The manufacturer only recommends API Certified engine oils. CAUTION! Do not use chemical flush ...

    Trailer Sway Control (TSC)
    TSC uses sensors in the vehicle to recognize an excessively swaying trailer and will take the appropriate actions to attempt to stop the sway. The system may reduce engine power and apply the brak ...

    Loose Fuel Filler Cap Message
    If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a loose gascap indicator will display in the EVIC telltale display area. Refer ...