Activating Adaptive Cruise Control (ACC)

You can only activate ACC if the vehicle speed is above 20 mph (32 km/h).

When the system is turned on and in the READY state, the Electronic Vehicle Information Center (EVIC) displays “Adaptive Cruise Ready.” When the system is OFF, the EVIC displays “Adaptive Cruise Control Off.”

NOTE: You cannot enable ACC under the following conditions:

• When in Four-Wheel Drive Low.

• When you apply the brakes.

• When the parking brake is set.

• When the automatic transmission is in PARK, REVERSE or NEUTRAL.

• When pushing the RES + button without a previously set speed in memory.

    See also:

    Quadra-Trac I Operating Instructions/Precautions – If Equipped
    The Quadra-Trac I is a single-speed (HI range only) transfer case, which provides convenient full-time fourwheel drive. No driver interaction is required. The Brake Traction Control (BTC) System ...

    Elapsed Time
    Shows the total elapsed time of travel since the last reset. Elapsed time will increment when the ignition switch is in the RUN or START position. Elapsed time is displayed as follows: hours:min ...

    Turning Confirmation Prompts ON/OFF
    Turning confirmation prompts off will stop the system from confirming your choices (e.g., the Uconnect™ Phone will not repeat a phone number before you dial it). • Press the button to begin. ...