Ignition Off Operation
The power sunroof switches can be programmed to remain active for up to approximately ten minutes after the ignition switch has been turned OFF. Refer to “Electronic Vehicle Information Center (EVIC)/Customer- Programmable Features (System Setup)” in “Understanding Your Instrument Panel” for further information.
NOTE: Opening either front door will cancel this feature.
See also:
Manual Compass Calibration
If the compass appears erratic and the “CAL” indicator does not appear in the
EVIC display, you must put the compass into the Calibration Mode manually as follows:
1. Start the engine. Leave th ...
Crossing Puddles, Pools, Flooded Areas Or Other Standing Water
Puddles, pools, flooded or other standing water areas normally contain murky
or muddy waters. These water types normally contain hidden obstacles and make it
difficult to determine an accurate wat ...
Programming A Non-Rolling Code
For programming Garage Door Openers manufactured
before 1995.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
away from the HomeLink ...