Using The Remote Control

1. Press the MODE button on the Remote Control.

2. While looking at Screen 1, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then press ENTER.

Select DISC Mode On The VES Screen
Select DISC Mode On The VES Screen

NOTE:
• Channel/Screen 1 select mode information is shown on the left side of the screen.

• Channel/Screen 2 select mode information is shown on the right side of the screen.

    See also:

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood Aja ...

    ESN/SID Access
    With the ignition switch in the ON/RUN or ACC position and the radio on, press the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is selected. Press the TUNE/SCROLL con ...

    Customer Assistance For The Hearing Or Speech Impaired (TDD/TTY)
    To assist customers who have hearing difficulties, the manufacturer has installed special TDD (Telecommunication Devices for the Deaf) equipment at its customer center. Any hearing or speech impai ...