Controls
The headphone power indicator and controls are located on the right ear cup.
NOTE: The rear video system must be turned on before sound can be heard from the headphones. To conserve battery life, the headphones will automatically turn off approximately three minutes after the rear video system is turned off.
Changing the Audio Mode for Headphones
1. Ensure the Remote Control channel/screen selector switch is in the same position as the headphone selector switch..
NOTE:
• When both switches are on Channel 1, the Remote is
controlling Channel 1 and the headphones are tuned
to the audio of the VES™ Channel 1.
• When both switches are on Channel 2, the Remote is controlling Channel 2 and the headphones are tuned to the audio of the VES™ Channel 2.
2. Press the MODE button on the remote control.
3. If the video screen is displaying a video source (such as a DVD Video), pressing STATUS shows the status on a popup banner at the bottom of the screen. Pressing the MODE button will advance to the next mode. When the mode is in an audio only source (such as FM), the Mode Selection menu appears on screen.
4. When the Mode Selection menu appears on screen, use the cursor buttons on the remote control to navigate to the available modes and press the ENTER button to select the new mode.
5. To cancel out of the Mode Selection
See also:
High Intensity Discharge Headlamps (HID) – If Equipped
The headlamps are a type of high voltage discharge tube.
High voltage can remain in the circuit even with the
headlamp switch off and the key removed. Because of
this, you should not attempt to s ...
Jeep Trail Rated
All 2011 Jeep Grand Cherokees equipped with either the off-road or the
Quadra-Lift group are Trail Rated®. The Jeep Trail Rated badge on the 2011 Jeep
Grand Cherokee indicates that the vehicle ha ...
Adding Fluid
Fluid should be added only to fill hole until fluid begins
to run out of the hole. ...


