Listening To Audio With The Screen Closed
To listen to only audio portion of the channel with the screen closed:
• Set the audio to the desired source and channel.
• Close the video screen.
• To change the current audio mode, press the remote control’s MODE button. This will automatically select the next available audio mode without using the Mode Select menu.
• When the screen is reopened, the video screen will automatically turn back on and show the appropriate display menu or media.
If the screen is closed and there is no audio heard, verify that the headphones are turned on (the ON indicator is illuminated) and the headphone selector switch is on the desired channel. If the headphones are turned on, press the remote control’s power button to turn audio on. If audio is still not heard, check that fully charged batteries are installed in the headphones.
See also:
Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is in the RUN or START position.
Elapsed time is displayed as follows:
hours:minute ...
Programming A Rolling Code
For programming garage door openers that were manufactured
after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is a ...
Select Another Mobile Phone
This feature allows you to select and start using another phone paired with the
Uconnect™ Phone.
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “S ...


