Rear License Lamp

1. Use a screw driver to gently pry against the side of the snap tab to remove the license lamp lens.

2. Pull bulb from socket.

3. Replace bulb.

4. Reinstall lens.

    See also:

    General Information
    This device complies with part 15 of the FCC rules and RSS 210 of Industry Canada. Operation is subject to the following conditions: • This device may not cause harmful interference. • This de ...

    Toggling Between Calls
    If two calls are in progress (one active and one on hold), press the button until you hear a single beep, indicating that the active and hold status of the two calls have switched. Only one c ...

    Media Center 130 With Satellite Radio (Sales Code RES+RSC)
    NOTE: The radio sales code is located on the lower right side of the radio faceplate. Media Center 130 (RES/RSC) ...