Manufacturing
The 2008 Jeep Liberty will be built using Chrysler Group's modern production process, called the Flexible Manufacturing Strategy (FMS). FMS allows multiple products to be produced at one plant in a time-efficient manner that are a higher quality for lower cost. At the core of the new manufacturing process is the heavy use of robots at the Toledo (Ohio) North Assembly Plant.
See also:
Front Panel(s) Installation With Rear Hard Top Removed
1. Turn the left and right panels over and move the spacer block (located on
the rear of the panel) upward 90 degrees.
NOTE: The front panel(s) must be positioned properly to ensure sealing. Set ...
Headlights And Parking Lights
Turn the end of the multifunction lever to the first detent
for parking light operation. Turn the end of the lever to
the second detent for headlight operation.
Headlight Switch ...
To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time, or allow the engine to run
for the entire 15-minute cycle.
NOTE: To avoid unintentional shut downs, the system will disable the one time
press ...


