To Arm The System
1. Remove the key from the ignition switch and exit the vehicle.
2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) transmitter.
NOTE: The Vehicle Security Alarm will not arm if you lock the doors with the manual door lock plungers or the driver’s door lock cylinder.
3. Close all doors. The Vehicle Security Light in the instrument cluster will flash rapidly for about 16 seconds to signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the liftgate will cancel the arming process. If the Vehicle Security Alarm is set successfully, the Vehicle Security Light will flash at a slower rate to indicate the alarm is armed.
NOTE: For added security, whenever the Security Alarm is armed, the HomeLink /Garage Door Opener (if equipped) is disabled as well.
See also:
Using ACC On Hills
When driving on hills, ACC may not detect a vehicle in
your lane. Depending on the speed, vehicle load, traffic
conditions, and the steepness of the hills, ACC performance
may be limited.
...
SMS
Uconnect™ Phone can read or send new messages on
your phone.
Read Messages:
If you receive a new text message while your phone is
connected to Uconnect™ Phone, an announcement will
be made ...
Instrument Panel Dimmer
Rotate the center portion of the lever to the extreme bottom position to fully
dim the instrument panel lights and prevent the interior lights from illuminating
when a door is opened.
Rotate the ...