To Disarm The System
Either press the UNLOCK button on the RKE transmitter or insert a valid Sentry Key into the ignition lock cylinder and turn the key to the ON/RUN position.
NOTE:
• Unlocking the doors with the manual door lock plungers
or the driver’s door lock cylinder will not disarm
the Vehicle Security Alarm.
• When the Vehicle Security Alarm is armed, the interior power door lock switches will not unlock the doors.
The Vehicle Security Alarm is designed to protect your vehicle; however, you can create conditions where the Vehicle Security Alarm will give you a false alarm. If the previously described arming sequence has occurred, the Vehicle Security Alarm will arm regardless of whether you are inside or outside the vehicle. If you remain inside the vehicle and open a door, the alarm will sound. If this occurs, disarm the Vehicle Security Alarm.
Tamper Alert
If something has triggered the Vehicle Security Alarm in your absence, the horn will sound three times and the exterior lights blink three times when you unlock the doors. Check the vehicle for tampering.
See also:
Delete/Erase “All” Uconnect™ Phonebook Entries
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
“Phonebook Erase All”.
• The Uconnect™ Phone will ask you to verify that you
wish to delete a ...
Onboard Diagnostic System — OBD II
Your vehicle is equipped with a sophisticated onboard diagnostic system called
OBD II. This system monitors the performance of the emissions, engine, and automatic
transmission control systems. Wh ...
Windshield Wipers And Washers
The windshield wiper/washer control lever is located on the right side of the
steering column. The front wipers are operated by rotating a switch, located at
the end of the lever. For information ...


