To Enter Remote Start Mode

Press and release the REMOTE START button

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.

NOTE:
• If your power door locks were unlocked, Remote Start will automatically lock the doors.

• If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.

• For security, power window operation and sunroof or Sky Slider operation (if equipped) is disabled when the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.

    See also:

    High Intensity Discharge Headlamps (HID) – If Equipped
    The headlamps are a type of high voltage discharge tube. High voltage can remain in the circuit even with the headlamp switch off and the key removed. Because of this, you should not attempt to s ...

    Disc Formats
    The VES™ DVD player is capable of playing the following types of discs (12 mm or 8 mm diameter): • DVD-Video discs (MPEG-2 video compression) (see notes about DVD Region Codes) • DVD-Aud ...

    Starting Procedures
    Before starting your vehicle, adjust your seat, adjust both inside and outside mirrors, and fasten your seat belts. WARNING! • When leaving the vehicle, always remove the key fob from the ign ...