To Exit Remote Start Mode And Drive The Vehicle

Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.

NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.

    See also:

    Lap/Shoulder Belt Untwisting Procedure
    Use the following procedure to untwist a twisted lap/ shoulder belt. 1. Position the latch plate as close as possible to the anchor point. 2. At about 6 to 12 in (15 to 30 cm) above the latch pl ...

    Towing Requirements
    To promote proper break-in of your new vehicle drivetrain components, the following guidelines are recommended: NOTE: Trailer towing requires special rear axle lubricant. Refer to “Fluids, Lubri ...

    Tire Size
    The tire size on the label represents the actual tire size on your vehicle. Replacement tires must be equal to the load capacity of this tire size. ...