Reset
It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure:
1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
2. Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.
See also:
Replacing The Batteries
The remote control requires two AAA batteries for operation.
To replace the batteries:
• Locate the battery compartment on the back of the
remote, then slide the battery cover downward.
• Rep ...
Satellite Radio
To switch to satellite radio mode, say “Sat” or “Satellite Radio”. In this mode,
you may say the following commands:
• “Channel Number” (to change the channel by its spoken number)
...
Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch
located in the switch bank of the instrument panel or
through the Customer-Programmable Features section of
the EVIC. The available choices ar ...