Advanced Front Air Bag Features
The Advanced Front Air Bag system has multistage driver and front passenger air bags. This system provides output appropriate to the severity and type of collision as determined by the Occupant Restraint Controller (ORC), which may receive information from the front impact sensors.
The first stage inflator is triggered immediately during an impact that requires air bag deployment. This low output is used in less severe collisions. Ahigher energy output is used for more severe collisions.
NOTE: The passenger Advanced Front Air Bag may not deploy, even when the driver Advanced Front Air Bag has, if the Occupant Classification System (refer to Occupant Classification System ) has determined the passenger seat is empty or is occupied by someone that is classified in the child size category. This could be a child, teenager, or even an adult.
WARNING!
• No objects should be placed over or near the air
bag on the instrument panel, because any such
objects could cause harm if the vehicle is in a
collision severe enough to cause the air bag to
inflate.
• Do not put anything on or around the air bag covers or attempt to manually open them. You may damage the air bags and you could be injured because the air bags may no longer be functional.
These protective covers for the air bag cushions are designed to open only when the air bags are inflating.
• Do not use accessory seat covers or place objects between you and the side air bags; the performance could be adversely affected and/or objects could be pushed into you, causing serious injury.
• Do not drill, cut or tamper with the knee bolster in any way.
• Do not mount any accessories to the knee bolster such as alarm lights, stereos, citizen band radios, etc.
• Do not have any accessory items installed which will alter the roof, including adding a sunroof to your vehicle. Do not add roof racks that require permanent attachments (bolts or screws) for installation on the vehicle roof. Do not drill into the roof of the vehicle for any reason.
See also:
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended th ...
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes. Note that all
cha ...
Customer Key Programming
If you have two valid Sentry Keys , you can program new Sentry Keys to the system
by performing the following procedure:
1. Cut the additional Sentry Key Transponder blank(s) to match the ignition ...