Call By Saying A Name

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Call”.

• The system will prompt you to say the name of the person you want to call.

• After the “Ready” prompt and the following beep, say the name of the person you want to call. For example, you can say “John Doe”, where John Doe is a previously stored name entry in the Uconnect™ phonebook or downloaded phonebook. To learn how to store a name in the phonebook, refer to “Add Names to Your Uconnect™ Phonebook”, in the phonebook.

• The Uconnect™ system will confirm the name and then dial the corresponding phone number, which may appear in the display of certain radios.

    See also:

    Before You Begin Programming HomeLink
    Be sure that your vehicle is parked outside of the garage before you begin programming. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended th ...

    Calibrate Compass
    Refer to “Compass Display” for more information. ...

    List Or Browse Mode
    During Play mode, pressing any of the buttons described below, will bring up List mode. List mode enables scrolling through the list of menus and tracks on the audio device. • TUNE control kn ...