List Paired Mobile Phone Names
• Press the 
button to
begin.
• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.
• When prompted, say “List Phones”.
• The Uconnect™ Phone will play the phone names of
all paired mobile phones in order from the highest to
the lowest priority. To “Select” or “Delete” a paired
phone being announced, press the 
button and
say “Select” or “Delete”. Also, see the next two sections
for an alternate way to “Select” or “Delete” a
paired phone.
See also:
Raising The Soft Top
1. Unclip and move the sun visors to the side.
2. Install door frames, if removed. Refer to “Door Frame” in this section for
further information.
3. Make sure the plastic sleeve is slid over S ...
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beam headlights until the lever is
released.
NOTE: If the m ...
Memo
To switch to the voice recorder mode, say “Memo”. In this mode, you may say the
following commands:
• “New Memo” (to record a new memo) — During the recording, you may press the Voice
...