SMS

Uconnect™ Phone can read or send new messages on your phone.

Read Messages:

If you receive a new text message while your phone is connected to Uconnect™ Phone, an announcement will be made to notify you that you have a new text message.

If you wish to hear the new message:

• Press the • After the “Ready” prompt and the following beep, say button.

• After the “Ready” prompt and the following beep, say “SMS Read” or “Read Messages.” • Uconnect™ Phone will play the new text message for you.

After reading a message, you can “Reply” or “Forward” the message using Uconnect™ Phone.

Send Messages:

You can send messages using Uconnect™ Phone. To send a new message:

• Press the • After the “Ready” prompt and the following beep, say button.

• After the “Ready” prompt and the following beep, say “SMS Send” or “Send Message.” • You can either say the message you wish to send or say “List Messages.” There are 20 preset messages.

To send a message, press the while the button while the system is listing the message and say “Send.” Uconnect™ Phone will prompt you to say the name or number of the person you wish to send the message to.

List of Preset Messages:
1. Yes
2. No
3. Where are you?
4. I need more direction.
5. L O L
6. Why
7. I love you
8. Call me
9. Call me later
10. Thanks
11. See You in 15 minutes
12. I am on my way
13. I’ll be late
14. Are you there yet?
15. Where are we meeting?
16. Can this wait?
17. Bye for now
18. When can we meet
19. Send number to call
20. Start without me

Turn SMS Incoming Announcement ON/OFF

Turning the SMS Incoming Announcement OFF will stop the system from announcing the new incoming messages.

• Press the • After the “Ready” prompt and the following beep, say button.

• After the “Ready” prompt and the following beep, say “Setup, SMS Incoming Message Announcement,” you will then be given a choice to change it.

    See also:

    Reverse Shifting
    To shift into REVERSE, bring the vehicle to a complete stop. Press the clutch and pause briefly to allow the gear train to stop rotating. Beginning from the NEUTRAL position, move the shift lever ...

    Rear Tail, Stop, Turn Signal, And Backup Lamp
    1. Remove the two inboard screws attaching the tail light housing to the body. DO NOT REMOVE THE OUTER SCREWS AT ANY TIME. 2. Separate the housing from the body by pushing the lamp inboard while ...

    Electronic Speed Control – If Equipped
    − Do not use in hilly terrain or with heavy loads. − When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cru ...