Voice Command System Operation
This Voice Command system allows you to control your AM, FM radio, satellite radio, disc player, and a memo recorder.
NOTE: Take care to speak into the Voice Interface System as calmly and normally as possible. The ability of the Voice Interface System to recognize user voice commands may be negatively affected by rapid speaking or a raised voice level.
WARNING!
Any voice commanded system should be used only
in safe driving conditions following local laws. All
attention should be kept on the roadway ahead.
Failure to do so may result in a collision causing serious injury or death.
When you press the Voice Command
button, you
will hear a beep. The beep is your signal to give a
command.
NOTE: If you do not say a command within a few seconds, the system will present you with a list of options.
If you ever wish to interrupt the system while it lists
options, press the Voice Command
button, listen
for the beep, and say your command.
Pressing the Voice Command button
while the
system is speaking is known as “barging in.” The system
will be interrupted, and after the beep, you can add or
change commands. This will become helpful once you
start to learn the options.
NOTE: At any time, you can say the words “Cancel”, “Help” or “Main Menu”.
These commands are universal and can be used from any menu. All other commands can be used depending upon the active application.
When using this system, you should speak clearly and at a normal speaking volume.
The system will best recognize your speech if the windows are closed, and the heater/air conditioning fan is set to low.
At any point, if the system does not recognize one of your commands, you will be prompted to repeat it.
To hear the first available Menu, press the Voice Command
button and say “Help” or “Main Menu”.
See also:
2011 Jeep Wrangler review
If the Donner Party had Jeeps, they never would have found themselves on the
menu.
Jeeps can eat up just about any trail.
During a recent rock crawl through Utah, the state where the actual Donn ...
Operating Instructions (Voice Command System) — If Equipped
Refer to “Voice Command” in the Uconnect™ User
Manual located on the DVD for further details. ...
Memo
To switch to the voice recorder mode, say “Memo”. In
this mode, you may say the following commands:
• “New Memo” (to record a new memo) — During the
recording, you may press the Voic ...