Memo

To switch to the voice recorder mode, say “Memo”. In this mode, you may say the following commands:
• “New Memo” (to record a new memo) — During the recording, you may press the Voice Command button to stop recording. You proceed by saying one of button to stop recording. You proceed by saying one of the following commands:
− “Save” (to save the memo)
− “Continue” (to continue recording)
− “Delete” (to delete the recording)
• “Play Memos” (to play previously recorded memos)
— During the playback you may press the Voice Command button to stop playing memos. You proceed by saying one of the following commands:
− “Repeat” (to repeat a memo)
− “Next” (to play the next memo)
− “Previous” (to play the previous memo)
− “Delete” (to delete a memo)
• “Delete All” (to delete all memos)

    See also:

    Barge In — Overriding Prompts
    The “Voice Command” button can be used when you wish to skip part of a prompt and issue your voice command immediately. For example, if a prompt is asking “Would you like to pair a phone, ...

    Console Storage Compartment
    To lock or unlock the storage compartment, insert the ignition key and turn. To open the storage compartment, press the latch and lift the cover. Center Console ...

    Operating Instructions — Radio Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. Power Switch/Volume Control (Rotary) Push the ON/VOLUME control knob to turn on the radio. Push the ON/VOLUM ...