High/Low Beam Switch

Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam.

    See also:

    Barge In — Overriding Prompts
    The “Voice Command” button can be used when you wish to skip part of a prompt and issue your voice command immediately. For example, if a prompt is asking “Would you like to pair a phone, ...

    Media Center 130 (Sales Code RES)
    NOTE: The radio sales code is located on the lower right side of the radio faceplate. Media Center 130 (RES) ...

    Reset
    • press the button. • After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”. This will delete all phone pairing, phone book entries, and other settings in al ...