Mist Feature

Push downward on the windshield wiper/washer control lever to activate a single wipe cycle to clear the windshield of road mist or spray from a passing vehicle.

The wipers will continue to operate until you release the lever.

NOTE: The mist feature does not activate the washer pump; therefore, no washer fluid will be sprayed on the windshield. The wash function must be used in order to spray the windshield with washer fluid.

Mist Control
Mist Control

    See also:

    Seat Belt Maintenance
    Do not bleach, dye or clean the belts with chemical solvents or abrasive cleaners. This will weaken the fabric. Sun damage will also weaken the fabric. If the belts need cleaning, use MOPAR Total ...

    Rear Axle Fluid Level Check
    The rear axle oil level needs to be between 1/8 in (3 mm) below the bottom of the fill hole and the bottom of the fill hole. The rear axle fill and drain plugs should be tightened to 22 to 29 f ...

    Select Another Mobile Phone
    This feature allows you to select and start using another phone paired with the Uconnect™ Phone. • Press the button to begin. • After the “Ready” prompt and the following beep, say “S ...