To Activate
Push the ON/OFF button. The Cruise Indicator Light in the instrument cluster will illuminate. To turn the system off, push the ON/OFF button a second time. The Cruise Indicator Light will turn off. The system should be turned off when not in use.
WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidentally
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always leave the system OFF when you are not using it.
See also:
Interior
The Compass' unibody platform and respectable but less ambitious ground
clearance make its floor lower and its cabin easier to enter than any of the
other Jeeps'. The standard upholstery is a stai ...
Points To Remember
NOTE: When the vehicle is stopped after a few miles/ kilometers of operation,
you may observe vapor coming from the front of the engine compartment. This is normally
a result of moisture from rain ...
At Each Oil Change
• Change the engine oil filter.
• Inspect the brake hoses and lines.
• Check the manual transmission fluid level.
CAUTION!
Failure to perform the required maintenance items may result in dam ...