Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch located in the switch bank of the instrument panel or through the Customer-Programmable Features section of the EVIC. The available choices are: OFF, Sound Only, or Sound and Display. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)” in “Understanding Your Instrument Panel” for further information.
When the ParkSense switch is pressed to disable the system, the instrument cluster will display the “PARK ASSIST OFF” message for approximately five seconds. Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information. When the shift lever is moved to REVERSE and the system is disabled, the EVIC will display the “PARK ASSIST OFF” message for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be ON when Park- Sense is disabled or defective. The ParkSense switch LED will be OFF when the system is enabled.
See also:
Emissions Inspection And Maintenance Programs
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require ...
Delete Uconnect™ Phone Paired Mobile Phones
• Press the button to
begin.
• After the “Ready” prompt and the following beep, say
“Setup Phone Pairing”.
• At the next prompt, say “Delete” and follow the
prompts.
• Yo ...
Electronic Volume Control
The electronic volume control turns continuously (360 degrees) in either direction,
without stopping. Turning the ON/VOLUME control knob to the right increases the
volume, and to the left decrease ...