Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage before you begin programming.
For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.
Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the Internet at www.HomeLink.com for information or assistance.
See also:
Driver And Passenger Advanced Front Air Bag Inflator Units
The Driver And Passenger Advanced Front Air Bag
Inflator Units are located in the center of the steering
wheel and on the right side of the instrument panel.
When the ORC detects a collision requ ...
Enhanced Seat Belt Use Reminder System (BeltAlert )
BeltAlert is a feature intended to remind the driver and
front passenger (if equipped with front passenger
BeltAlert ) to fasten their seat belts. The feature is active
whenever the ignition is ...
SEEK Button (CD MODE)
Press the right SEEK button for the next selection on the CD. Press the left
SEEK button to return to the beginning of the current selection, or return to the
beginning of the previous selection i ...


