Elapsed Time

Shows the total elapsed time of travel since the last reset.

Elapsed time will increment when the ignition switch is in the RUN or START position.

Elapsed time is displayed as follows:
hours:minutes:seconds

Elapsed time can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset all digits will change to zeros and time will start incrementing again if the ignition switch is in RUN or START.

    See also:

    Flash-To-Pass
    You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...

    At Each Oil Change
    • Change the engine oil filter. • Inspect the brake hoses and lines. • Check the manual transmission fluid level. CAUTION! Failure to perform the required maintenance items may result in dam ...

    Downshifting
    Moving from a high gear down to a lower gear is recommended to preserve brakes when driving down steep hills. In addition, downshifting at the right time provides better acceleration when you desi ...