Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord.
The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
See also:
Mist
Use the Mist feature when weather conditions make
occasional usage of the wipers necessary. Rotate the end
of the lever downward to the Mist position and release
for a single wiping cycle.
NOTE ...
Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is
in the RUN or START position.
Elapsed time is displayed as follows:
hours:min ...
Dial by Saying a Number
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Dial”.
• The system will prompt you to say the number you want to call.
• For example, you can ...