Shift Positions
The transfer case switch is located on the center console next to the shift lever.
Transfer Case Switch
2WD
Rear Wheel Drive High Range - This range is used for normal street and highway driving on dry hard-surfaced roads.
4WD Lock
Four-Wheel Drive High Range - This range locks the front driveshaft and rear driveshaft together forcing the front and rear wheels to rotate at the same speed. Additional traction for loose or slippery road surfaces only.
4WD Low
Four-Wheel Drive Low Range - This range provides low speed four-wheel drive. Locks the front driveshaft and rear driveshaft together forcing the front and rear wheels to rotate at the same speed. Additional traction and maximum pulling power for loose or slippery road surfaces only. Do not exceed 25 mph (40 km/h).
N
Neutral - This range disengages both the front driveshaft and rear driveshaft from the powertrain. To be used for flat towing behind another vehicle. Refer to “Recreational Towing” in “Starting and Operating” for further information.
See also:
Selection Of Lubricant
It is important that the proper lubricant is used in the
transmission to assure optimum transmission performance.
Use only the manufacturer’s recommended transmission
fluid. Refer to “Fluids, ...
Keyless Enter-N-Go
This feature allows the driver to operate
the ignition switch with the push
of a button, as long as the ENGINE
START/STOP button is installed and
the Remote Keyless Entry (RKE) transmitter
...
Lowering The Windshield And Removing Side Bars
1. Lower the fabric top or remove the hard top following the instructions in
this manual.
NOTE: To assist in properly reinstalling side bars, mark the original locations
prior to removing.
2. Re ...