Hazard Warning Flashers
The Hazard Warning flasher switch is located in the switch bank below the climate controls.
Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.
This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers may wear down your battery.
See also:
Engine Oil Selection
For best performance and maximum protection under all
types of operating conditions, the manufacturer recommends
engine oils that are API Certified and meet the
requirements of Chrysler Material ...
Special Additives
The manufacturer strongly recommends against the addition
of any additives to the transmission. The only
exception to this policy is the use of special dyes to aid in
detecting fluid leaks. The ...
High Range (Four-Wheel Drive Models) Or Two-Wheel Drive Models
On
This is the normal operating mode for ESC in 4WD HIGH
range and in two-wheel drive vehicles. Whenever the
vehicle is started or the transfer case (if equipped) is
shifted from 4WD LOW range ...