To Unlock The Doors
Press and release the UNLOCK button on the RKE transmitter once to unlock the driver’s door or twice to unlock all doors. The turn signal lamps will flash to acknowledge the unlock signal. The illuminated entry system will also turn on.
Refer to “Keyless Enter-N-Go” under “Things To Know Before Starting Your Vehicle” for further information.
See also:
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold
weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
...
Front/Rear Axle Fluid
For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons
the exterior surfaces of the axle assembly should be
inspected. If gear oil leaka ...
Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended th ...