To Enter Remote Start Mode

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.
The vehicle doors will lock, the parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15 minute cycle.
NOTE:
• If an engine fault is present or fuel level is low, the
vehicle will start and then shut down in 10 seconds.
• The park lamps will turn on and remain on during Remote Start mode.
• For security, power window and power sunroof operation (if equipped) are disabled when the vehicle is in the Remote Start mode.
• The engine can be started two consecutive times with the RKE transmitter. However, the ignition must be cycled by pushing the START/STOP button twice (or the ignition switch must be cycled to the ON/RUN position) before you can repeat the start sequence for a third cycle.
See also:
Display Units In
The EVIC can be changed between English and Metric units of measure. The units
apply to the Outside Temperature, Average Fuel Economy, and Distance to Empty.
To make your selection, press and relea ...
Disc
To switch to the disc mode, say “Disc”. In this mode, you
may say the following commands:
• “Track” (#) (to change the track)
• “Next Track” (to play the next track)
• “Pre ...
Supported MP3/WMA File Formats
The radio will recognize only files with the *.MP3/WMA extension as MP3/WMA files.
Non-MP3/WMA files named with the *.MP3/WMA extension may cause playback problems.
The radio is designed to recogn ...


