To Exit Remote Start Mode And Drive The Vehicle

Before the end of 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of the 15 minute cycle, press and release the START/STOP button. If the START/STOP button is not present, insert the Key Fob into the ignition switch and turn the switch to the ON/RUN position.

NOTE:
• For vehicles not equipped with the Keyless Enter- N-Go feature, the ignition switch must be in the ON/RUN position in order to drive the vehicle.

• For vehicles not equipped with the Keyless Enter- N-Go feature, the message “Remote Start Active — Insert Key and Turn To Run” will display in the EVIC until you insert the key. Refer to “Electronic Vehicle Information Center (EVIC)” for further information.

• For vehicles equipped with the Keyless Enter-N-Go feature, the message “Remote Start Active — Push Start Button” will display in the EVIC until you push the START button.

    See also:

    Electronic Serial Number/Sirius Identification Number (ESN/SID)
    Please have the following information available when calling: 1. The Electronic Serial Number/Sirius Identification Number (ESN/SID). 2. Your Vehicle Identification Number. To access the ESN/SI ...

    Auto Unlk On Exit
    When ON is selected, all doors will unlock when the vehicle is stopped and the transmission is in the PARK or NEUTRAL position and the driver’s door is opened. To make your selection, press and ...

    EVIC White Telltale Lights
    This area will show reconfigurable white caution telltales. These telltales include: • Shift Lever Status The shift lever status “P,R,N,D,L,5,4,3,2,1” are displayed indicating the shift lev ...