Resetting The Auto Up Feature
Should the Auto Up feature stop working, the window probably needs to be reset. To reset Auto Up: 1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
2. Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.
See also:
Power Inverter — If Equipped
There is a 115 Volt, 150Watt inverter outlet located on the front of the center
console to convert DC current to AC current. This outlet can power cellular phones,
electronics and other low power ...
Front Axle Fluid Level Check
The front axle oil level needs to be between 1/8 in (3 mm)
below the bottom of the fill hole and the bottom of the fill
hole.
The front axle fill and drain plugs should be tightened to
22 to 29 ...
Comfort had been issue
And while every Jeep nearly lived up to its long-built reputation for
off-road prowess, its interiors lacked the comfort and completeness it should
have. The plastic was hard, the features sparse. ...


