How To Disengage The Automatic Locking Mode
Unbuckle the combination lap/shoulder belt and allow it to retract completely to disengage the Automatic Locking Mode and activate the vehicle sensitive (emergency) locking mode.
WARNING!
• The belt and retractor assembly must be replaced
if the seat belt assembly Automatic Locking Retractor
(ALR) feature or any other seat belt function
is not working properly when checked according
to the procedures in the Service Manual.
• Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.
See also:
Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) —
If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prematurely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood A ...
Fuel Filler Cap (Gas Cap)
The gas cap is located behind the fuel filler door, on the
driver’s side of the vehicle. If the gas cap is lost or
damaged, be sure the replacement cap has been designed
for use with this vehi ...
Fluid Level Check
Lubricant should be at the bottom edge of the oil fill hole. ...