Call By Saying A Name
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Call”.
• The system will prompt you to say the name of the person you want to call.
• After the “Ready” prompt and the following beep, say the name of the person you want to call. For example, you can say “John Doe”, where John Doe is a previously stored name entry in the Uconnect™ phonebook or downloaded phonebook. To learn how to store a name in the phonebook, refer to “Add Names to Your Uconnect™ Phonebook”, in the phonebook.
• The Uconnect™ system will confirm the name and then dial the corresponding phone number, which may appear in the display of certain radios.
See also:
Entering From The Rear
Vehicles that come up from behind your vehicle on either
side and enter the rear detection zone with a relative
speed of less than 30 mph (48 km/h).
Rear Monitoring ...
Media Center 130 (Sales Code RES)
NOTE: The radio sales code is located on the lower right
side of the radio faceplate.
Media Center 130 (RES) ...
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord. ...