Redial

• Press the • After the “Ready” prompt and the following beep, say button to begin.

• After the “Ready” prompt and the following beep, say “Redial”.

• The Uconnect™ Phone will call the last number that was dialed from your mobile phone.

NOTE: This may not be the last number dialed from the Uconnect™ Phone.

    See also:

    Electronic Vehicle Information Center (EVIC) Displays
    When the appropriate conditions exist, the EVIC displays the following messages: • Vehicle Not in Park • Key Left Vehicle • Key Not Detected • Service TPM System (refer to “Tire Pr ...

    High/Low Beam Switch
    Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...

    Parking Brake
    Before leaving the vehicle, make sure that the parking brake is fully applied. Also, be certain to leave an automatic transmission in PARK, or manual transmission in REVERSE or first gear. The pa ...