See also:

Rear Tail, Stop, Turn Signal, And Backup Lamp
1. Remove the two inboard screws attaching the tail light housing to the body. DO NOT REMOVE THE OUTER SCREWS AT ANY TIME. 2. Separate the housing from the body by pushing the lamp inboard while ...

Jump-Starting Procedure
WARNING! Failure to follow this procedure could result in personal injury or property damage due to battery explosion. CAUTION! Failure to follow these procedures could result in damage to the ch ...

Raising The Soft Top
1. Unclip and move the sun visors to the side. 2. Install door frames, if removed. Refer to “Door Frame” in this section for further information. 3. Make sure the plastic sleeve is slid over S ...