Voice Command

• For best performance, adjust the rearview mirror to provide at least 1⁄2 in (1 cm) gap between the overhead console (if equipped) and the mirror.

• Always wait for the beep before speaking.

• Speak normally, without pausing, just as you would speak to a person sitting a few feet/meters away from you.

• Make sure that no one other than you is speaking during a Voice Command period.

• Performance is maximized under:
• low-to-medium blower setting,
• low-to-medium vehicle speed,
• low road noise,
• smooth road surface,
• fully closed windows,
• dry weather condition.

• Even though the system is designed for users speaking in North American English, French, and Spanish accents, the system may not always work for some.

• When navigating through an automated system such as voice mail, or when sending a page, at the end of speaking the digit string, make sure to say “Send”.

• Storing names in the phonebook when the vehicle is not in motion is recommended.

• It is not recommended to store similar sounding names in the Uconnect™ Phonebook.

• Phonebook (Downloaded and Uconnect™ Phone Local) name recognition rate is optimized when the entries are not similar.

• Numbers must be spoken in single digits. “800” must be spoken “eight-zero-zero” not “eight hundred”.

• You can say “O” (letter “O”) for “0” (zero).

• Even though international dialing for most number combinations is supported, some shortcut dialing number combinations may not be supported.

• In a convertible vehicle, system performance may be compromised with the convertible top down.

    See also:

    Classic Exterior Design
    Every surface of the all-new Jeep Grand Cherokee is new and treated for aerodynamics. This improves fuel efficiency and puts more fluidity into the design while delivering a 7- percent improvement ...

    When To Use 4L (Low) Range
    When off-road driving, shift into 4L (Low) for additional traction and control on slippery or difficult terrain, ascending or descending steep hills, and to increase low speed pulling power. This ...

    To Set A Desired ACC Speed
    When the vehicle reaches the speed desired, push the SET - button and release. The EVIC will display the set speed. ACC Set Remove your foot from the accelerator pedal. If you do not, the ve ...