To Set A Desired Speed

Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected speed.

NOTE: The vehicle should be traveling at a steady speed and on level ground before pressing the SET button.

    See also:

    Front/Rear Axle Fluid
    For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leaka ...

    Operating Information And Precautions
    The Command-Trac II transfer case provides four positions: • Two–wheel drive (2WD) high range • Four-wheel drive (4WD LOCK) high range • Four-wheel drive (4WD LOW) low range • Neutra ...

    Emergency Fuel Filler Door Release
    If you are unable to open the fuel filler door, use the fuel filler door emergency release. 1. Open the liftgate. 2. Push down on the inboard edge of the left storage bin, this will pop up the o ...