To Deactivate

A soft tap on the brake pedal, pushing the CANCEL button, or normal brake pressure while slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed memory. Pressing the ON/OFF button or turning the ignition switch OFF erases the set speed memory.

    See also:

    Shift Positions
    For additional information on the appropriate use of each transfer case mode position, see the information below: 2H Position This range is used for normal street and highway driving on hard-surfa ...

    Language Selection
    To change the language that the Uconnect™ Phone is using: • Press the button to begin. • After the “Ready” prompt and the following beep, say the name of the language you wish to swit ...

    Automatic Unlock Doors On Exit Programming
    The “Automatic Unlock Doors On Exit” feature can be enabled or disabled as follows: 1. Close all doors and place the key in the ignition. 2. Cycle the ignition switch between LOCK and ON/ RUN an ...